Deck Rider Bar

3/8 inch" Fixture for Holding Multiple Parts in Place for Complete Blast Cleaning.

Half inch Plate with Holes

Half inch fabrication Plate with Holes Rolled to Match the Carousel Table Inside of a Shot Blast Cabinet. The Holes are Countersunk to Allow the Attachment Hardware to be Flush with Surface of the Wear Plate.

1 inch Plate with Holes

1 inch Thick fabrication Plate with Holes Held in Place by Counter Sunk Screws. The fabrication Plate Has Been Milled to Allow the Head of the Screw to be Flush with Surface of the Wear Plate.

Side Rail

Fabrication Side Rail for a Conveyor. 1" Diameter fabrication Round Bar Chamfered and Welded to a 1/2" Thick fabrication Plate. The Slotted Holes Allow for Vertical Adjustment.

1/4 inch Seal Rings

Shot Blast Machines

Shot Blast Machines Showing Fabrication Table Liner, Table Ring, Hanging Liners, and Blast Wheel Housing. (left picture) Shot Blast Machine Showing Fabrication Table Liner, Table Ring, and Wall Liners. (right picture)

Plate Door Liners

Shot Blast Trees

Perforated Plate

Perforated Plate

Feed Roller

Rock Truck Bed Liner Kit

Grizzly Bars

Fabrication can be Flame Cut/Plasma Cut. Grizzly Bars (shown to the left) after two years of service. Prior to switching to fabrication, the customer was building up bars yearly. fabrication side plates show little wear after two years

Universal Processor

Manganal teeth fabricated for processor before demolition of Adams Mark Hotel in Philadelphia. Processed 50,000 yards of concrete. Very little wear at end of job

Dredge

Dredge

Dredge built with mild steel lasted two months. Customer switched to stainless and then to 400 BHN, each lasted two months, then tried to overlay with ceramic which lasted three days. Finally switched to manganal and is showing no wear after seven months.

Impactor

Impactor used to break up concrete. Manganal blocks in great condition after three years.

Screen Bucket

Bucket fabricated to screen large rock Manganal bar is a perfect application.